COSMOS LAC Metal Primer

• A quick drying primer for the perfect pre-treatment of metal surfaces
• Protected from rust
• Improves the adhesion of the top coat on metallic surfaces
• High filling power
• Improves the gloss level of the topcoat
• Protects against oxidation
• Drying time varies depending on temperature and humidity and might take afew hours
• Easily applied
• 400ml

FLAT JET WIDE CAP

-Flat spray trajectory
-Vertical or horizontal
-Smooth & even
-Ideal for fill-ins
-Calligraphic effects

Can be applied over any metal surface to protect it from rust and to ensure better
adhesion for paints to be applied later.

Shake the container at least 3 minutes after you hear the mixing ball. Before the first use spray it in the air for 3-4 seconds to remove any condensed colour. After use hold the aerosol upside down and press the actuator for 2-3 seconds to clean the valve. If the nozzle is blocked, replace it with a new one. Use outdoors or in a well-ventilated area such as an open garage. Optimal application at temperature: 10-25°C and humidity below 65% to ensure proper drying. Storage 5-35°C.

• Ensure the surface is clean, dry and free of grease.
• Wear protective gloves, protective clothing, eye/face protection.
• Always paint in an open space in the open air.
• The space should be as dust-free as possible.
• Protect the surrounding area from overspray. Before you are ready to prime,
• you need to protect your tire and valve stem from overspray. The easiest way to do this is with painter’s tape and newspaper or plastic or a stack of index cards.
• Sand back with a fine-grit sandpaper and carefully remove all residue afterwards.
• Test spray on a non-visible area.
• Spray with the can in a vertical position, otherwise the paint might spread unevenly.
• Spray surface from a distance of 25-30cms.
• Paint first vertically and then horizontally.
• Apply Special Metal Primer in several thin layers, spraying in sweeping motions.
• Allow each coating to dry for at least 5 minutes.
• Can be overpainted after 3 hours.
• Immediately after applying your final coat, carefully remove the painter’s tape and index cards from the tire. Then, wait for the paint to dry to the
• touch before carefully removing the garbage bags.
• After use, clean the spray valve (turn the aerosol upside down and push the nozzle for about 5 seconds).