COSMOS LAC Master Mechanic N1 PRIMER

• Colours: White, Grey
• Gloss
• Ideal quick-drying primer for pre-treating the metal surfaces
• Provides anti-rust protection
• Good isolation through spots
• Improves the adhesion of the top coat
• Excellent filling properties
• Improves the gloss level of the topcoat
• Protects against oxidation
• High temperature resistant
• Very thick and fast drying
• Really elastic and durable in the long run
• Easy to use and easy to sand
• Uniform, smooth finish
• Viscosity: 18-25 sec
• Density: 0.6-0.8 g/L
• Drying time: Touch (20°C, Humidity<65%): 5-10min,
  Through dry (20°C, Humidity <65%): 1h, Maximum hardness: 24h
• Coverage: 5m2/L
• Made in Europe
• Contents: 500ml

• SMART CAP
  
  – Less overspray
  – Extreme coverage
  – Fast drying
  – Hard chisel lines
  – Even coating
  – Suitably for effects
  – Dual way spraying

It is a top quality surfacer that is perfect for use on all surfaces except plastic.

Shake the container at least 3 minutes after you hear the mixing ball. Before the first use spray it in the air for 3-4 seconds to remove any condensed color. After use hold the aerosol upside down and press the actuator for 2-3 seconds to clean the valve. If the nozzle is blocked, replace it with a new one. Use outdoors or in a well-ventilated area such as an open garage. Optimal application at temperature: 10-25°C and humidity below 65% to ensure proper drying. Storage 5-35°C.

• Ensure the surface is clean, dry and free of grease
• Wear protective gloves, protective clothing, eye/face protection
• Always paint in an open space in the open air
• The space should be as dust-free as possible
• Protect the surrounding area from overspray. Before primer application, protect, your tire and valve stem from overspray. The easiest way to do this is with painter’s tape and newspaper or plastic or a stack of index cards
• You need to sand back with a fine-grit sandpaper and carefully remove all residue afterwards
• Test spray on a testing area
• Always spray with the can in a vertical position otherwise, the paint might 'spit' unevenly
• Spray surface from a distance of 25-30cm
• Paint first vertically and then horizontally
• Apply Special Metal Primer in several thin layers, spraying in sweeping motions
• Allow each coating to dry for at least 5 minutes
• Can be overpainted after 3 hours
• Immediately after applying your final coat, carefully remove the painter’s tape and index cards from the tire. Then, wait for the paint to dry to the touch before carefully removing the garbage bags
• After use, clean the spray valve (turn the aerosol upside down and push the nozzle for about 5 seconds)