COSMOS LAC Forest & Trail Marking
Forest & Trail Marking is a high visibility spray designed for marking wood and stone surfaces. Equipped with two nozzles: one for small surfaces and one for large surfaces.
Durable and long-lasting, with an endurance of 2 - 4 years.
FEATURES
- Colours: Red, Yellow, Blue & White
- Deep matte color
- Two nozzles included
- Exceptional luminosity
- Can be used upside down without blocking
- Highly pigmented acrylic paint compound
- Non-drip, non-dribble formula
- Good adhesion
- Recommended minimum coat: one
- Permanent and resilient: UV-resistant and weather-resistant
- Easily-achieved fading, stenciling and blending effects
- Durability: 2-4 years
- Made in Europe
- Contents: 500 ml
APPLICATION
Suitable for DIY or professional use on multiple surfaces: streets, stone, concrete buildings, ground and metal.
CAP SYSTEM
-
WHITE/ BLUE SOFT CAP
- Fine spray
- Soft spray touch
- Ideal for details
- No drips
-
RED NEEDLE LINER CAP
- Medium Output Cap
- Perfect for detailing, pencil like lines
- Useful for rough edge lines, drips, texture and splatter effects
- No drips
INSTRUCTIONS FOR USE
Shake the container at least 3 minutes after you hear the mixing ball. Before the first use spray it in the air for 3-4 seconds to remove any condensed color. After use hold the aerosol upside down and press the actuator for 2-3 seconds to clean the valve. If the nozzle is blocked, replace it with a new one. Use outdoors or in a well-ventilated area such as an open garage. Optimal application at temperature: 10-25°C and humidity below 65% to ensure proper drying. Storage 5-35°C.
TIPS:
- Ensure the surface is clean, dry and free of grease
- Wear protective gloves, protective clothing, eye/face protection
- Always paint in an open space in the open air
- The space should be as dust-free as possible
- Protect the surrounding area from overspray. Before primer application, protect, your tire and valve stem from overspray. The easiest way to do this is with painter’s tape and newspaper or plastic or a stack of index cards
- You need to sand back with a fine-grit sandpaper and carefully remove all residue afterwards
- Test spray on a testing area
- Always spray with the can in a vertical position otherwise, the paint might 'spit' unevenly
- Spray surface from a distance of 25-30cm
- Paint first vertically and then horizontally
- Apply Special Metal Primer in several thin layers, spraying in sweeping motions
- Allow each coating to dry for at least 5 minutes
- Can be overpainted after 3 hours
- Immediately after applying your final coat, carefully remove the painter’s tape and index cards from the tire. Then, wait for the paint to dry to the touch before carefully removing the garbage bags
- After use, clean the spray valve (turn the aerosol upside down and push the nozzle for about 5 seconds)