COSMOS LAC Acrylic Varnish

• 100% gloss acrylic varnish
• Αdds a sheen, protects and resists dirt retention
• Dries clear to a flexible, non-tacky, hard surface
• Increases brightness and colour saturation
• Adjusts and unifies surface sheen
• Improves surface durability - ideal when shipping or exhibiting
• Protects colours from UV light damage
• Resists discolouration - yellowing and fogging - caused by humidity, heat and UV
• Depending on the substrate it allows surface moisture to pass through and breathe
• Allows for easy cleaning without fear of damaging the acrylic paint film
• Has excellent levelling properties - will not hold brush marks
• Transparent when dry
• Flexible & non-cracking
• Water-resistant when dry
• Ideal for complete coverage of heavy textures and vertical applications
• Designed for interior and exterior use
• 400ml

SMART CAP

– Less overspray
– Extreme coverage
– Fast drying
– Hard chisel lines
– Even coating
– Suitably for effects
– Dual way spraying

Can be used on any surface.

Shake the container at least 3 minutes after you hear the mixing ball. Before the first use spray it in the air for 3-4 seconds. After use turn the aerosol upside down and press the actuator for 2-3 seconds to clean the valve. If the nozzle is blocked, replace it with a new one. Use outdoors or in a well-ventilated area such as an open garage. Optimal application at temperature: 10-25°C and humidity below 65% to ensure proper drying. Storage 5-35°C.

• Ensure the surface is clean, dry, and free of grease
• Wear protective gloves, protective clothing, eye/face protection
• Always paint in an open space in the open air
• The space should be as dust-free as possible
• Protect the surrounding area from overspray
• Test spray on a non-visible area
• Always spray with the can in a vertical position, otherwise the paint might 'spit' unevenly
• Spray surface from a distance of 25-30cm
• Apply in several thin layers, spraying in sweeping motions
• Don't go over bits you have missed, but leave to dry and then re-varnish area. Don't go back over areas you have already done, as this can cause clouding
• Don't attempt to remove once applied
• Do not use with any non-acrylic media
• After use, clean the spray valve (turn the aerosol upside down and push the nozzle for about 5 seconds)