COSMOS LAC Metal Primer

Quick dry aerosol alkyd primer, formulated for application to all metal surfaces for protection against rust and to improve paint adhesion, when applied. Excellent coverage and filling properties. It can be painted over with alkyd or acrylic top coat colours. Available in 3 colours.

FEATURES

• A quick drying primer for the perfect pre-treatment of metal surfaces
• Protected from rust
• Improves the adhesion of the top coat on metallic surfaces
• High filling power
• Improves the gloss level of the topcoat
• Protects against oxidation
• Drying time varies depending on temperature and humidity and might take afew hours
• Easily applied
• 400ml

APPLICATION

Can be applied over any metal surface to protect it from rust and to ensure better
adhesion for paints to be applied later.

CAP SYSTEM

FLAT JET WIDE CAP

-Flat spray trajectory
-Vertical or horizontal
-Smooth & even
-Ideal for fill-ins
-Calligraphic effects

INSTRUCTIONS FOR USE

Shake the container at least 3 minutes after you hear the mixing ball. Before the first use spray it in the air for 3-4 seconds to remove any condensed colour. After use hold the aerosol upside down and press the actuator for 2-3 seconds to clean the valve. If the nozzle is blocked, replace it with a new one. Use outdoors or in a well-ventilated area such as an open garage. Optimal application at temperature: 10-25°C and humidity below 65% to ensure proper drying. Storage 5-35°C.

TIPS:

• Ensure the surface is clean, dry and free of grease.
• Wear protective gloves, protective clothing, eye/face protection.
• Always paint in an open space in the open air.
• The space should be as dust-free as possible.
• Protect the surrounding area from overspray. Before you are ready to prime,
• you need to protect your tire and valve stem from overspray. The easiest way to do this is with painter’s tape and newspaper or plastic or a stack of index cards.
• Sand back with a fine-grit sandpaper and carefully remove all residue afterwards.
• Test spray on a non-visible area. 
• Spray with the can in a vertical position, otherwise the paint might spread unevenly.
• Spray surface from a distance of 25-30cms.
• Paint first vertically and then horizontally.
• Apply Special Metal Primer in several thin layers, spraying in sweeping motions.
• Allow each coating to dry for at least 5 minutes.
• Can be overpainted after 3 hours.
• Immediately after applying your final coat, carefully remove the painter’s tape and index cards from the tire. Then, wait for the paint to dry to the
• touch before carefully removing the garbage bags.
• After use, clean the spray valve (turn the aerosol upside down and push the nozzle for about 5 seconds).